COMPRESSIBILITY OF SOILS
Summary
Highlights
Introduction to Soil Compressibility and Settlement Types00:00:00
The lesson begins by defining soil compressibility as the tendency of soil to decrease in volume under increased stress. It explains how structural loads transfer to the soil, causing settlement. Three main types of settlement are discussed: elastic or immediate settlement (occurring shortly after load application without moisture change), primary consolidation settlement (dissipation of pore water pressure in saturated clays), and secondary consolidation settlement (gradual structural adjustment over time).
Elastic Settlement Calculation00:06:00
This section details the formula for immediate settlement of a perfectly flexible foundation, defining variables such as net applied pressure (Q), Poisson's ratio, modulus of elasticity of soil (Es), foundation dimension (B), influence factor (I), and depth factor (If). A sample problem is solved to calculate immediate settlement for both rigid and flexible rectangular footings under uniform contact pressure.
Stress History of Clays and Primary Consolidation00:11:28
The video explains normally consolidated clay (where current pressure is the maximum past pressure) versus over consolidated clay (which experienced higher past pressure). It introduces the Over Consolidation Ratio (OCR) and formulas for primary consolidation settlement using compression index (Cc) and swell index (Cs). Three sample cases are solved: normally consolidated clay, over consolidated clay where final pressure is below preconsolidation pressure, and over consolidated clay where final pressure exceeds preconsolidation pressure.
Secondary Consolidation Settlement00:34:22
This part discusses secondary consolidation, which continues after primary consolidation due to gradual adjustment of soil particles under sustained stress, especially in soft clay and organic soils. It introduces the secondary compression index (C alpha) and provides equations for calculating secondary settlement. A sample problem calculates total consolidation settlement by adding primary and secondary components.
Terzaghi's Time Rate Theory00:41:42
Terzaghi's one-dimensional consolidation theory is presented to explain how excess pore water pressure dissipates over time in saturated clay. Six assumptions of the theory are listed. Key parameters include coefficient of volume compressibility, coefficient of consolidation, and time factor. The section explains drainage paths for single versus double drainage and provides formulas relating degree of consolidation to time factor, followed by sample problems calculating field consolidation time and coefficient of consolidation.
Settlement Under a Foundation and Final Example01:03:28
The final topic addresses how stress from a footing distributes non-uniformly with depth. It explains using Simpson's rule to calculate the average increase in effective pressure within a clay layer by weighting stress increases at the top, middle, and bottom. A final sample problem calculates the settlement of a 3-m thick clay layer under a square footing using the weighted average stress method and compression index.
Recently Summarized Articles
Related summaries
- TOTAL DRAMA ISLAND Episode 9 - "Paintball Deer Hunter"
- 如何重设你的潜意识?一定要仔细认真看,看明白 | 这将100%改变你的人生剧本 - Dr. Joe Dispenza 博士 (中英字幕)
- TOTAL DRAMA ISLAND Episode 4 - "Dodgebrawl"
- What NASA Found Below Jupiter's Clouds
- TOTAL DRAMA ISLAND Episode 5 - "Not Quite Famous"
- When Europeans Were Slaves | History Of The Barbary Slave Trade