Summary
Highlights
Remove the protective film from the battery and insert the visor clip. Do not hold the remote too close to the opener during programming.
This video is a visual aid for programming your remote control and not a substitute for the owner's manual. Always refer to your manual for detailed instructions and safety warnings.
A moving door can cause serious injury or death. Keep children away from the door and do not allow them to play with controls. Review your manual for all safety points before proceeding with installation.
You have 30 seconds to complete each programming step. If two red LEDs flash, you have run out of time and must restart the step. You can restart as many times as needed.
Press and hold the square program set button until the round LED turns blue. When the long LED flashes purple, press and release your chosen remote button. The long LED turns solid purple. Press and release the same remote button again. Both LEDs will flash blue and turn off. Press and release the button one more time, and the door should operate.
Repeat these steps for additional remotes. To program the same remote for other openers, use the other two remote buttons. Each remote can be programmed for up to three openers.