Initial Layer Flow Ratio Calibration: What It Is, What It Does, and Why It Matters

Share

Summary

A detailed guide explaining the Initial Layer Flow Ratio setting in Bambu Studio and OrcaSlicer, covering how to calibrate it for better first-layer adhesion and surface quality.

Initial Layer Flow Ratio Calibration: What It Is, What It Does, and Why It Matters

Source: 3dbite.com/initial-layer-flow-ratio-calibration-bambu-studio

Highlights

Understanding Initial Layer Flow Ratio

The initial layer flow ratio is a multiplier applied to the extrusion rate for the first layer only. A value of 1.0 extrudes exactly what the slicer calculates, while values like 0.95 or 1.02 adjust the amount by percentages. Unlike the ordinary filament flow ratio, which affects the whole print, this setting isolates the first layer because it is deposited onto a bare plate and squashed by the nozzle gap, making its behavior dependent on the plate type, nozzle gap, and filament.

Why It Matters

This setting is critical for prints with visible bottom surfaces (like lithophanes), improving adhesion on large flat parts, and adjusting to new or different plates such as Bambu's Cool Plate SuperTack. It also prevents users from distorting their global flow ratio just to fix the first layer. Too much flow causes bulging and ridges, while too little leads to gaps and a weak base.

How to Locate and Calibrate

In Bambu Studio, the setting is hidden under Preferences > Develop mode, then found in Process settings under the Quality tab. In OrcaSlicer, it is called 'Bottom surface flow ratio'. Before calibrating, users should clean the plate, verify Z offset, ensure filament is dry, and calibrate the main filament flow ratio first. Calibration is done using test prints with multiple first-layer patches at different ratios to identify the smoothest, most continuous surface.

Practical Considerations and Troubleshooting

There is no universal value for this setting; it depends on the specific combination of plate, nozzle size, and filament. Users should avoid copying values from others and instead calibrate for their own setup. Common symptoms include gaps indicating under-extrusion or a 'cat's tongue' texture indicating over-extrusion. The result should be saved in a named process preset, as it is a process setting that applies only to the current project.

Recently Summarized Articles

Loading...
Summarize another web page →